Concrete Repair & Resurfacing in Columbus, OH

Extend the life of your flatwork with professional concrete repair in Columbus, OH. We fix cracks, spalling, and uneven slabs on driveways, patios, and sidewalks. When full replacement is not required, resurfacing and leveling can restore appearance and safety at a lower cost.

Primetime Concrete Columbus provides professional concrete repair throughout Columbus, OH and the surrounding area. Our licensed, insured crew delivers safe, clean, on-time work with a free estimate before anything begins. Call (614) 826-6493 or request your free quote.

Concrete repair in Columbus that fixes the cause, not just the cracks

Concrete here in Columbus takes a beating. Freeze-thaw cycles, road salt, heavy trucks, and drainage issues can all crack, pit, or sink your concrete. At Primetime Concrete Columbus, our concrete repair and resurfacing work starts with figuring out why the damage happened in the first place, so it does not come right back.

On a typical visit, we walk the entire area with you and look for patterns. Long, straight cracks might point to poor control joint layout. Spiderweb cracking can mean a weak mix or surface that was finished too early. Heaving corners near a downspout often mean drainage or gutter problems. For exterior slabs in Columbus, we also check how water flows during a storm and where snow piles up in winter.

We explain what is cosmetic and what is structural. Hairline cracks in a wide driveway panel may just need sealing to keep salt and water out, while lateral displacement or different slab heights can be a trip hazard that calls for leveling or partial replacement. You get clear options and prices in writing before we touch anything, so you can decide whether to repair, resurface, or in severe cases replace specific sections instead of the whole slab.

How our concrete repair process actually works

Once you approve a plan, Primetime Concrete Columbus follows a step-by-step repair process tailored to your slab.

1) Cleaning and prep: We power wash or mechanically clean the concrete to remove dirt, sealers, and loose material. For older Columbus driveways that have seen years of de-icer, this step is essential so new products bond correctly.

2) Crack and spall repair: We route larger cracks to create a clean, consistent groove, then install a flexible or rigid repair material depending on the location. Control joints and expansion joints often get a flexible urethane sealant, while structural cracks may get a high strength repair mortar or epoxy. Spalled areas (where the top surface has popped off) are chipped back to solid concrete, then rebuilt with a polymer modified repair mortar that bonds tightly to the old slab.

3) Leveling and trip hazard removal: If one part of the slab has sunk or heaved, we look at concrete leveling options. For many sidewalks and some interior slabs we can raise low panels using a pressure injected grout. Where leveling is not appropriate, we may grind transitions to remove lips along joints. The goal is a safer, smoother surface that meets local codes for trip hazards.

4) Surface refinement: After patching and leveling, we blend repaired areas with the surrounding surface. This can include light grinding, feathering patch edges, and re-cutting control joints so everything looks intentional rather than spot patched.

Throughout the process, we protect nearby landscaping, siding, and garage doors. At the end, we clean up dust and debris so you are not left with a mess.

Concrete resurfacing to refresh worn driveways, patios, and walks

When the surface of your concrete is ugly but the base is still solid, resurfacing can save you thousands over full replacement. Primetime Concrete Columbus uses high performance concrete resurfacing systems designed for Ohio’s climate.

Resurfacing begins with aggressive surface prep. We typically grind or shot blast the slab to open up the pores and remove old sealers, paints, and weak cream. Any cracks, holes, and spalled spots are repaired first so they do not telegraph through the new surface.

We then apply a polymer modified cement overlay, usually at 1/16 to 1/4 inch thick, depending on how damaged the surface is. These overlays bond chemically and mechanically to the original slab and are formulated to handle freeze-thaw cycles and de-icing salts common around Columbus. For driveways, we often recommend a broom or textured finish to improve traction in slushy winters. For patios and pool decks, we can use a knockdown or light texture that stays more comfortable under bare feet in summer.

Color and design options are flexible. We can match a plain gray concrete look, add integral color for a warmer tone, or apply stains and accent colors for a decorative finish. Borders, subtle patterns, and saw cut designs can break up large slabs so they look more like stone or large pavers without the higher cost and maintenance.

After the overlay cures, we apply a sealer compatible with the system you chose. For driveways in central Ohio, we often recommend a penetrating sealer that helps resist salt and moisture without making the surface slick. Patios and decorative areas may get a light sheen or color enhancing sealer instead. We walk you through cure times and when you can walk, move furniture, and drive on the new surface so you do not accidentally damage it while it is still green.

Columbus climate, timing, and what affects your concrete repair cost

Local weather has a big impact on when and how concrete repair and resurfacing should be done. In Columbus we try to schedule most exterior overlay work when overnight lows stay above about 45 degrees and the daytime surface temperature is between roughly 50 and 85. Working in the heart of winter risks freezing the repair before it cures, and pouring in extreme summer heat can cause rapid moisture loss and weak bonds unless we take extra precautions.

Rain matters too. Many repair materials need a dry surface at installation and a few hours without rain to set. When we plan your project, Primetime Concrete Columbus will watch the forecast and may recommend specific days or start times to avoid pop up storms that are common here in late spring and summer.

Several factors drive your final cost:

• Size of the area: A small porch has a higher cost per square foot than a large driveway because setup and mobilization are the same either way.

• Condition of the existing concrete: Heavy spalling, deep cracks, or previous failed coatings mean more prep time and materials. That can be the difference between a simple clean-and-seal and a full resurfacing system.

• Leveling or structural issues: If sections have settled, especially along garages or city sidewalks, lifting or partial replacement will cost more than cosmetic work alone. Sometimes we coordinate with the City of Columbus when sidewalk panels in the right-of-way are involved.

• Finish and options: A basic broom finish resurfacing is more affordable than multi-color decorative finishes with borders or saw cut patterns.

We are transparent about costs and will tell you honestly when repair is not a good investment, for example if the base is failing or large sections are crumbling. In those cases, we often suggest selective replacement combined with resurfacing for the remaining areas to balance budget and longevity.

What to expect when you hire Primetime Concrete Columbus

From the first visit, we focus on making the process clear and low stress. During our on-site assessment we listen to how you actually use the space. A driveway that takes delivery trucks needs a different approach than a light use patio. We photograph problem areas, take measurements, and test for hollow spots or delamination where the surface has separated from the base concrete.

Before work begins, you receive a written proposal that spells out exactly what type of concrete repair or resurfacing we will perform, what products we are using, any color or finish choices, estimated timeline, and what you need to do beforehand (like moving vehicles, planters, or furniture). If your project is near property lines or city right-of-way, we point that out so there are no surprises.

On repair day, our crew arrives on time, walks the site with you, and confirms the plan. We set up dust control where needed, especially in garages or near entry doors. While we work, you will see us repeatedly checking temperatures, mix ratios, and cure times. This is not overkill. In a climate like Columbus where conditions change quickly, those checks are what make repairs last.

Once the work is complete, we go over maintenance tips suited to central Ohio. That typically includes using a good penetrating sealer every few years, minimizing harsh de-icers (especially first winter after resurfacing), and rinsing off salt and fertilizer in early spring. We also explain what is normal aging hairline cracks and slight color variation and what would be considered a warranty issue so you know when to call us.

Whether you have a sinking front walk in Clintonville, a pitted driveway in Hilliard, or a flaking patio in Pickerington, Primetime Concrete Columbus is ready to help you choose the right concrete repair solution and get more usable years out of the concrete you already have.